Datasheet

www.ti.com

Appendix A Summary of Using Code Composer Studio v3.3

This appendix describes the basic steps on how to use Code Composer Studio v3.3, or CCS, to compile

firmware for UCD3138. The design flow describes detailed steps for firmware code creation and firmware

debugging.

A.1 Set Up Code Composer Studio v3.3 for UCD3138

The recommended version of Code Composer Studio is version 3.3 (v3.3). After completing the CCS v3.3

installation, and when CCS is opened for the first time, the window shown in Figure 14 prompts users to

select the required configuration. For UCD3138 device, please select ARM7 SIMULATOR BIG ENDIAN.

Click ADD and then Save & Quit.

If CCS has existing configurations in My System, click Launch Setup under File pull-down menu. Select

Remove All to remove the existing configurations; then select ARM7 SIMULATOR BIG ENDIAN as shown

in Figure 14, Click ADD and then Save & Quit for UCD3138 device.

Figure 14. Set Up Code Composer Studio v3.3 for UCD3138

Summary of Using Code Composer Studio v3.3 SLUU886A–February 2012–Revised July 2013

Submit Documentation Feedback