Datasheet
+ V
FA
-
R
CS
+
–
DRV
CS
C
DD
VDD
GND
R
S1
R
S2
VS
C
OUT
V
OUT
C
B2
Np
Ns
Na
V
AUX
R
PL
VAC
CBC
HV
UCC28710
SOIC-7
R
LC
+ V
F
-
V
BLK
C
B1
R
CBC
UCC28710, UCC28711
UCC28712, UCC28713
UCC28714, UCC28715
www.ti.com
SLUSB86 –NOVEMBER 2012
DESIGN PROCEDURE
This procedure outlines the steps to design a constant-voltage, constant-current flyback converter using the
UCC28710 family of controllers. Refer to the Figure 20 for component names and network locations. The design
procedure equations use terms that are defined below.
Figure 20. Design Procedure Application Example
Definition of Terms
Capacitance Terms in Farads
• C
BULK
: total input capacitance of C
B1
and C
B2
.
• C
DD
: minimum required capacitance on the VDD pin.
• C
OUT
: minimum output capacitance required.
Duty Cycle Terms
• D
MAGCC
: secondary diode conduction duty cycle in CC, 0.425.
• D
MAX
: MOSFET on-time duty cycle.
Frequency Terms in Hertz
• f
LINE
: minimum line frequency.
• f
MAX
: target full-load maximum switching frequency of the converter.
• f
MIN
: minimum switching frequency of the converter, add 15% margin over the f
SW(min)
limit of the device.
• f
SW(min)
: minimum switching frequency (see ELECTRICAL CHARACTERISTICS).
Current Terms in Amperes
• I
OCC
: converter output constant-current target.
• I
PP(max)
: maximum transformer primary current.
• I
START
: start-up bias supply current (see ELECTRICAL CHARACTERISTICS).
• I
TRAN
: required positive load-step current.
• I
VSL(run)
: VS pin run current (see ELECTRICAL CHARACTERISTICS).
Copyright © 2012, Texas Instruments Incorporated Submit Documentation Feedback 19
Product Folder Links: UCC28710, UCC28711 UCC28712, UCC28713 UCC28714, UCC28715