Datasheet

+
_
Load 1
3.3V/35A
V2
+
FAN
DC
Source
_
V1
+
_
8V 2
nd
Bias
+
_
A1
Enable
A B
A B
EN ON
www.ti.com Test Setup
5 Test Setup
5.1 Test Equipment
Voltage source for main power: HP 6015A DC power supply
Voltage source for secondary initial bias: 8.0-V/0.1-A DC voltage source compatible
Multimeters: Fluke 45 dual display multimeter
Output load: HP 6060A DC electronic load
Oscilloscope: Tektronix TDS 460 A 400 MHz
Fan: 200 LFM minimum compatible
Recommended wire gauge: AWG #18 for input voltage connection. AWG #16 for output load connection.
5.2 Recommended Test Setup
Figure 2. Recommended Test Set Up
5
SLUU441A– September 2010– Revised October 2011 Half-Bridge DC-to-DC Converter —With Secondary-Side Control
Submit Documentation Feedback
Copyright © 2010–2011, Texas Instruments Incorporated