Datasheet

Improved Error Amplifier
REF
VSENSE
+
-
COMP
4.95V
C
Z
R
Z
C
P
+
+
COMP
VSENSE
Soft Start
6V
5.75V
6.45V
OV
PWM
Shutdown
160mA
g
m
+
R Q
QS
+
0.5V
Brownout
EN
UV
OV
(UCC28061)
UCC28060
www.ti.com .................................................................................................................................................... SLUS767E – MAY 2007 – REVISED NOVEMBER 2008
The voltage error amplifier is a transconductance amplifier. Voltage loop compensation is connected from the
error amplifier output, COMP, to analog ground, AGND. The recommended compensation network is shown in
Figure 28 .
Figure 28. Typical Error Amplifier Compensation
To improve the transient response, the error amplifier output current is increased by 100 µ A when the error amp
input is below 5.815 V, as shown in Figure 29 . This increase allows faster charging of the compensation
components following sudden load current increases (also refer to Figure 4 in the Typical Characteristics ).
Figure 29. Error Amplifier Block Diagram Showing Speed-Up and Latched Soft-Start
Copyright © 2007 – 2008, Texas Instruments Incorporated Submit Documentation Feedback 21
Product Folder Link(s): UCC28060