Datasheet

TVP5150AM1

SLES209E–NOVEMBER 2007–REVISED OCTOBER 2011

www.ti.com

5 Example Register Settings

The following example register settings are provided only as a reference. These settings, given the

assumed input connector, video format, and output format, set up the TVP5150AM1 decoder and provide

video output. Example register settings for other features and the VBI data processor are not provided

here.

5.1 Example 1

5.1.1 Assumptions

Device: TVP5150AM1

Input connector: Composite (AIP1A)

Video format: NTSC-M, PAL (B, G, H, I), or SECAM

NOTE

NTSC-4.43, PAL-N, and PAL-M are masked from the autoswitch process by default. See the

autoswitch mask register at address 04h.

Output format: 8-bit ITU-R BT.656 with embedded syncs

5.1.2 Recommended Settings

Recommended I

C writes: For this setup, only one write is required. All other registers are set up by

default.

C register address 03h = Miscellaneous controls register address

C data 09h = Enables YCbCr output and the clock output

NOTE

HSYNC, VSYNC/PALI, AVID, and FID/GLCO are high impedance by default. See the

miscellaneous control register at address 03h.

Submit Documentation Feedback