Datasheet

TVP5147M1

SLES140G –JULY 2005–REVISED FEBRUARY 2012

www.ti.com

Table 2-18. Color Killer Register

Subaddress 05h

Default 10h

7 6 5 4 3 2 1 0

Reserved Automatic color killer Color killer threshold [4:0]

Automatic color killer:

00 = Automatic mode (default)

01 = Reserved

10 = Color killer enabled, the UV terminals are forced to a zero color state

11 = Color killer disabled

Color killer threshold [4:0]:

11111 = 31 (maximum)

10000 = 16 (default)

00000 = 0 (minimum)

Table 2-19. Luminance Processing Control 1 Register

Subaddress 06h

Default 00h

7 6 5 4 3 2 1 0

Reserved Pedestal not Reserved VBI raw Luminance signal delay [3:0]

present

Pedestal not present:

0 = 7.5 IRE pedestal is present on the analog video input signal (default)

1 = Pedestal is not present on the analog video input signal

VBI raw:

0 = Disable (default)

1 = Enable

During the duration of the vertical blanking as defined by VBLK start and stop registers 22h through 25h, the chroma samples are

replaced by luma samples. This feature may be used to support VBI processing performed by an external device during the vertical

blanking interval. To use this bit, the output format must be the 10-bit, ITU-R BT.656 mode.

Luminance signal delay [3:0]: Luminance signal delays respect to chroma signal in 1× pixel clock increments.

0111 = Reserved

0110 = 6 pixel clocks delay

0001 = 1 pixel clock delay

0000 = 0 pixel clock delay (default)

1111 = –1 pixel clock delay

1000 = –8 pixel clock delay

Submit Documentation Feedback

Product Folder Link(s): TVP5147M1