Datasheet
6-MHz Clock
Signal
BUSPWR
DP1
DM1
DP2
DM2
DP3
DM3
PWRON1
PWRON2
PWRON3
OVRCUR1
OVRCUR2
OVRCUR3
DP0
DM0
V
CC
GND
XTAL1/CLK48
XTAL2
EXTMEM
RESET
5 V
3.3 V
GND
D +
D -
Upstream
Port
3.3 V LDO
§
SN75240
†
EN1
OC1
D +
D -
5 V
GND
D +
D -
5 V
D +
D -
5 V
Downstream
Ports
5-V Board Power
Supply
TUSB2036
TPS2044
†
A
B
C
D
100 mF
‡
SN75240
†
A
B
C
D
GND
GND
100 mF
‡
100 mF
‡
SN75240
†
A
B
5 V
GND
C
D
4.7 mF
0.1 mF
4.7 mF
EN2
EN3
EN4
OC2
OC3
OC4
OUT4
OUT3
OUT2
OUT1
EEDATA/GANGED
System
Power-On Reset
IN1
0.1 mF
IN2
15 kΩ
15 kΩ
15 kΩ
15 kΩ
1.5 kΩ
3.3 V
15 kΩ
15 kΩ
3.3 V
NP3
NPINT1
NPINT0
MODE
DP0PUR
OCPROT/PWRSW
¶
NOTES:
LDO is a 5-V-to-3.3-V voltage regulator. TPS76333 from Texas Instruments can be used.
All USB DP, DM signal pairs require series resistors of approximately 27
†
¶
TPS2042 and SN75240 are Texas Instruments devices. Two TPS2042 devices can be substituted for the TPS2044.
120 µF per hub is the minimum required per the USB specification. However, TI recommends a 100-µF, low ESR,
tantalum capacitor per port for immunity to voltage droop.
‡
§
Ω to ensure proper termination. An optional filter
capacitor of about 22 pF is recommended for EMI suppression. This capacitor, if used, must be placed between the hub
terminal and the series resistor, as per section 7.1.6 of the USB specification.
TUSB2036
www.ti.com
SLLS372F –MARCH 2000–REVISED SEPTEMBER 2013
Self-Powered Hub, Individual-Port Power Management
In a self-powered configuration, the TUSB2036 can be implemented for individual-port power management when
used with the TPS2044 because it is capable of supplying 500 mA of current to each downstream port and can
provide current limiting on a per-port basis. When the hub detects a fault on a downstream port, power is
removed from only the port with the fault and the remaining ports continue to operate normally. Self-powered
hubs are required to implement overcurrent protection and report overcurrent conditions. The SN75240 transient
suppressors reduce inrush current and voltage spikes on the data lines.
Figure 12. TUSB2036 Self-Powered Hub, Individual-Port Power-Management Application
Copyright © 2000–2013, Texas Instruments Incorporated Submit Documentation Feedback 15
Product Folder Links: TUSB2036