Datasheet

www.ti.com

Software Control

Table 2. Main Window Description (continued)

Section Description

Power Down, Reset, Mode Allows for powering down and resetting the part. Also controls the mode of the LMK04800.

Select

CLKin Settings Enabled and select the input clock source, input buffer types, and dividers.

VCO Divider Set the VCO divider to reduce the frequency on the clock distribution path. Use the VCO directly.

OSCout Control power to the OSCin port. Also enable and change parameters of the OSCout pins.

PLL 1 Settings Configure PLL 1 settings when using the dual PLL mode.

PLL 2 Settings Configure PLL 2 settings for both dual and single PLL mode.

2.2.2 LMK04800 Outputs Tab

After clicking on the LMK04800 Outputs tab, the display looks as shown in Figure 3.

Figure 3. LMK04800 Output Tab

Table 3. LMK04800 Output Tab Description

Section Description

Clock Out 0 and 1 Configure Clock Out 0 and 1 outputs. Enable the outputs and set the divider, delay, and output buffer.

Clock Out 2 and 3 Configure Clock Out 2 and 3 outputs. Enable the outputs and set the divider, delay, and output buffer.

Clock Out 4 and 5 Configure Clock Out 4 and 5 outputs. Enable the outputs and set the divider, delay, and output buffer.

Clock Out 6 and 7 Configure Clock Out 6 and 7 outputs. Enable the outputs and set the divider, delay, and output buffer. Also

select the source for the output.

SLAU454–July 2012 TSW4806EVM

Submit Documentation Feedback