Datasheet

Unpacking the EVM
2-2
2.1 Unpacking the EVM
Unpacking the TSC2301EVM, check to make sure you received all the
material that should be in the box. The EVM kit should include the following:
- TSC2301EVM board, PWB 6438187
- CD-ROM, 6438190
If any of these components is missing, contact Texas Instruments for a
replacement.
2.2 Default Configuration
The TSC2301EVM features a few simple means of configuring its operation.
The default settings for these items are shown in Table 2-1. When you unpack
your TSC2301EVM, make sure that your board is initially configured as shown
here.
Table 2-1.Default Configuration Settings
Board Identifier Description Default Setting
JMP1 SPI clock polarity select 2 to 3
JMP2 LINE IN left attenuator Installed
JMP3 LINE IN right attenuator Installed
JMP4 MIC BIAS select 2 to 3
JMP5 PWR select 1 to 2
JMP6 A1 select for EEPROM Installed
2.3 Quick Start
Once the TSC2301EVM has been unpacked and you have verified that the
board is configured as shown in Table 2-1, install the software.
Place the CD-ROM into your PC’s CD-ROM drive. Locate the Setup program
on the disk, and run it. The Setup program installs the TSC2301EVM software
on your PC. Note that if you are running Windows 2000 or XP, you need ad-
ministrator privileges to install the software. Follow the instructions that the in-
staller gives you.
When the installation is complete, connect a USB cable from your PC to the
TSC2301EVM. You may see a message that a Human Interface Device has
been connected. Once this connection has been made, launch the
TSC2301EVM software on your PC.
The software should automatically find the TSC2301EVM. If the board is
found, the screen shown in Figure 2-1 appears.