Datasheet

www.ti.com
Getting Started
Table 2. USBMODEVM Board Default Configuration Settings
Board Description Default Settings
Identifier
SW1 Onboard power supply enable SW1-1: +1.8VD Enable On: Enabled
SW1-2: +3.3VD Enable On: Enabled
SW2 On/Off board control selection SW2-1: Onboard EEPROM address bit A0 On: A0=0
SW2-2: Onboard EEPROM address bit A1 Off: A1=1
SW2-3: Onboard EEPROM address bit A2 On: A2=0
SW2-4: Onboard I2S On: Onboard
SW2-5: Onboard MCLK On: Onboard
SW2-6: Onboard SPI On: Onboard
SW2-7: Onboard RESET On: Onboard
SW2-8: External MCLK from J10 (EXT MCK) Off: Not EXT
JMP1 +5VA and +5VD connection Installed: Connect +5VA to +5VD Installed
Removed: Disconnect +5VA to +5VD
JMP2 AGND and DGND connection Installed: Connect AGND to DGND Removed
Removed: Disconnect AGND to DGND
JMP3 JMP3 Connect I2C SDA pull-up to IOVDD Removed
JMP4 JMP4 Connect I2C SCL pull-up to IOVDD Removed
JMP5 SPI /SS select Connect 1 ~ 2: /SS from CNTL Connect 2 ~ 3 (FSX)
Connect 2 ~ 3: /SS from FSX
JMP6 Board power selection Connect 1 ~ 2: +5VD from USB Connect 1 ~ 2
(USB)
Connect 2 ~ 3: +5VD from U2
JMP7 IOVDD power selection Connect 1 ~ 2: IOVDD +5VD Connect 3 ~ 4
(+3.3VD)
Connect 3 ~ 4: IOVDD = +3.3VD
Connect 5 ~ 6: IOVDD = +1.8VD
JMP8 JMP8 TAS1020B P1.3 GPIO connection Removed
JMP9 JMP9 TAS1020B P1.2 GPIO connection Removed
JMP10 JMP10 TAS1020B P1.1 GPIO connection Removed
JMP11 JMP11 TAS1020B P1.0 GPIO connection Removed
JMP12 JMP12 TAS1020B P3.5 GPIO connection Removed
JMP13 JMP13 TAS1020B P3.4 GPIO connection Removed
JMP14 JMP14 TAS1020B P3.3 GPIO connection Removed
SLAU178 – April 2006 TSC2111EVM and TSC2111EVM-PDK 5
Submit Documentation Feedback