Datasheet

TSC2101
SLAS392D JUNE 2003 REVISED MAY 2005
www.ti.com
52
REGISTER 04H: Reset Control
BIT NAME
RESET
VALUE
READ/
WRITE
FUNCTION
D15D0 RSALL R/W FFFFH Reset All. Writing the code 0xBB00, as shown below, to this register causes the TSC2101 to reset
all its control registers to their default, powerup values.
1011101100000000 => Reset all control registers
Others => Do not write other sequences to the register.
REGISTER 05H: Configuration Control
BIT NAME
RESET
VALUE
READ/
WRITE
FUNCTION
D15D7 0’s R Reserved
D6 SWPDTD 0 R/W Software Powerdown Control for Pen Touch Detection
0 => Pen touch detection is enabled.
1 => Pen touch detection is disabled.
D5D3 PRECTM 000 R/W Precharge Time. These bits set the amount of time allowed for precharging any pin capacitance on
the touch screen prior to sensing if a screen touch is happening.
000 => 20 µs
001 => 84 µ
010 => 276 µ
011 => 340 µs
100 => 1.044 ms
101 => 1.108 ms
110 => 1.300 m
111 => 1.364 ms
D2D0 RPWUDL 000 R/W Sense Time. These bits set the amount of time the TSC2101 need to wait to sense a screen touch
between coordinate axes.
000 => 32 µs
001 => 96 µs
010 => 544 µs
011 => 608 µs
100 => 2.080 ms
101 => 2.144 m
110 => 2.592 ms
111 => 2.656 ms
REGISTER 06H: Temperature Max Threshold Measurement
BIT NAME
RESET
VALUE
READ/
WRITE
FUNCTION
D15D13 0’s R Reserved
D12 TMXES 0 R/W Max Temperature (TEMP1 or TEMP2) threshold check enable for Auto/NonAutoScan
Measurement.
0 => Max Temperature threshold check is disabled.
1 => Max Temperature threshold check is enabled.
Only valid for TEMP1 or TEMP2. Depends on bit TSCAN of control register 0CH/page 1 in case
of autoscan measurement and depends on bits ADCSM of control register 00H/page 1 in case
of nonautoscan measurement.
D11D0 TTHRESH FFFH R/W Temperature Max Threshold. When code due to temperature measurement goes above or equal
to programmed threshold value, interrupt is generated.