Datasheet

Quick Start
2-3
Getting Started
2.3 Quick Start
Once the TSC2101EVM has been unpacked and you have verified that the
board is configured as shown in Table 2−1, install the software.
Place the CD-ROM into the CD-ROM drive of the PC. Locate and run the Setup
program on the disk. The Setup program installs the TSC2101EVM software
on your PC. Note that if you are running Windows 2000 or XP, you need
administrator privileges to install the software. Follow the instructions provided
by the installer.
When the installation is complete, connect a USB cable from the PC to the
TSC2101EVM. When the TSC2101EVM is connected to the PC the first time,
the user may see a message that a Human Interface / Audio Device has been
connected. Once this connection has been made, launch the TSC2101EVM
software on the PC.
The software should automatically find the TSC2101EVM. If the board is
found, the screen shown in Figure 2−1 appears.
Figure 2−1. Default Software Screen