Datasheet

EVM-PDK Operation

www.ti.com

You are done and ready to run the TSC2017EVM software GUI.

6.2 Quick Start

In order to use the touch screen features, a four-wire resistive touch screen must be connected to J1 on

the TSC2017EVM. It is important to ensure that the connection between TSC2017 and the touch screen is

as short, simple, and secure as possible.

When both hardware and software installation/setup have completed successfully, attach a USB cable

from your PC to the USB-MODEVM Interface board (J7 on the motherboard). As configured at the factory,

the board is powered from the USB interface; no other external power supply is needed, and the power

indicator LEDs on the USB-MODEVM light up.

Also the yellow LED (D2, which is located next to the J7 USB plug) lights up to indicate that the processor

on the USB-MODEVM board works and runs the TSC firmware program properly.

Launch the TSC2017 evaluation software on your PC, which you just installed. The software automatically

finds the TSC2017EVM, and a screen similar to the one shown in Figure 2 appears.

Figure 2. TSC2017EVM-PDK Software GUI Screen

TSC2017EVM and TSC2017EVM-PDK SLAU305A–January 2010–Revised June 2010