Datasheet

www.ti.com

Kit Operation

Table 6. List of Jumpers

Jumper Shunt Position Jumper Description

JMP1 2-3 Analog power select (default is +3.3VD)

JMP2 Closed EEPROM address select. When installed and used with the USB-MODEVM, firmware for the

motherboard is executed from the EEPROM on the TSC2008EVM. This is the default mode.

6 Kit Operation

The following section provides information on using the TSC2008EVM-PDK, including setup, program

installation, and program usage.

6.1 TSC2008EVM-PDK Block Diagram

A block diagram of the TSC2008EVM-PDK is shown in Figure 1. The evaluation kit consists of two circuit

boards connected together. The motherboard is designated as the USB-MODEVM interface board; the

daughtercard is the TSC2008EVM described previously in this manual.

SLAU248–May 2008 TSC2008EVM and TSC2008EVM-PDK User's Guide

Submit Documentation Feedback