Datasheet

www.ti.com
Kit Operation
4. When this completes, click Finish on the TSC2004EVM installer window.
5. Restart your computer. (This step may not be necessary, but is suggested as a precaution).
6. When your computer is restarted, connect the TSC2004EVM via a USB cable to the computer.
Windows should recognize the new device, and Found New Hardware Wizard appears.
7. Select Install from a list or specific location (Advanced), and click on Next>.
8. Select Don't Search. I will Choose the driver to install, and click on Next>.
9. If TSC2004EVM is inside the list of Model, click on it to select it. You are done.
10. Otherwise, if it is not there, click on Have disk...
11. Select Browse ..., find the TSC2004EVM.inf, which is included with the installer, and click on it.
12. Your PC should install it.
13. Click on Finish to finish the correction.
14. You are done! Run the TSC2004EVM software.
When installation is complete, attach a USB cable from your PC to the USB-MODEVM Interface board. As
configured at the factory, the board is powered from the USB interface; so, the power indicator LEDs on
the USB-MODEVM should light. Once this occurs, launch the TSC2004 evaluation software on your PC.
The software should automatically find the TSC2004EVM, and a window box, similar to the one in
Figure 2 should appear.
Check the corresponding A0/A1 box, if TSC2004EVM JMP5/JMP6 is removed (high). By default, both A0
and A1 should be unchecked. Click on the OK button to continue, and the interface GUI (Figure 3 )
appears.
Figure 2. I
2
C Address Settings
SLAU215 – May 2007 TSC2004EVM and TSC2004EVM-PDK 7
Submit Documentation Feedback