Datasheet
SLLS423I − JUNE 2000 − REVISED MARCH 2005
29
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
POST OFFICE BOX 1443
• HOUSTON, TEXAS 77251−1443
APPLICATION INFORMATION
component connection (continued)
Outer Shield Termination
Chassis GND
Figure 12. Nonisolated Outer Shield Termination
LPS
LPS
10 kΩ
10 kΩ
Link Power
Square Wave Input
Figure 13. Nonisolated Circuit Connection Variations for LPS
LPS
13.7 kΩ
Square Wave Signal
10 kΩ
PHY V
DD
0.033 µF
PHY GND
NOTE: As long as the resistance ratio is maintained between 1.61:1 and
1.33:1, any values of resistors may be used.
Figure 14. Isolated Circuit Connection for LPS
crystal selection
The TSB41AB1 and other TI PHY devices are designed to use an external 24.576-MHz crystal connected
between the XI and XO terminals to provide the reference for an internal oscillator circuit. This oscillator in turn
drives a PLL circuit that generates the various clocks required for transmission and resynchronization of data
at the S100 through S400 media data rates.
A variation of less than ±100 ppm from nominal for the media data rates is required by IEEE Std 1394-1995.
Adjacent PHYs may therefore have a difference of up to 200 ppm from each other in their internal clocks, and
PHYs must be able to compensate for this difference over the maximum packet length. Larger clock variations
may cause resynchronization overflows or underflows, resulting in corrupted packet data.
For the TSB41AB1, the SYSCLK output may be used to measure the frequency accuracy and stability of the
internal oscillator and PLL from which it is derived. The frequency of the SYSCLK output must be within
±100 ppm of the nominal frequency of 49.152 MHz.