Datasheet
TS5V330
www.ti.com
.............................................................................................................................................................. SCDS164D – MAY 2004 – REVISED JUNE 2009
PARAMETER DEFINITIONS
PARAMETER DESCRIPTION
r
on
Resistance between the D and S ports, with the switch in the ON state
I
OZ
Output leakage current measured at the D and S ports, with the switch in the OFF state
I
OS
Short-circuit current measured at the I/O pins
V
IN
Voltage at IN
V
EN
Voltage at EN
C
IN
Capacitance at the control ( EN, IN) inputs
C
OFF
Capacitance at the analog I/O port when the switch is OFF
C
ON
Capacitance at the analog I/O port when the switch is ON
V
IH
Minimum input voltage for logic high for the control ( EN, IN) inputs
V
IL
Minimum input voltage for logic low for the control ( EN, IN) inputs
V
hys
Hysteresis voltage at the control ( EN, IN) inputs
V
IK
I/O and control ( EN, IN) inputs diode clamp voltage
V
I
Voltage applied to the D or S pins when D or S is the switch input
V
O
Voltage applied to the D or S pins when D or S is the switch output
I
IH
Input high leakage current of the control ( EN, IN) inputs
I
IL
Input low leakage current of the control ( EN, IN) inputs
I
I
Current into the D or S pins when D or S is the switch input
I
O
Current into the D or S pins when D or S is the switch output
I
off
Output leakage current measured at the D or S ports, with V
CC
= 0
t
ON
Propagation delay measured between 50% of the digital input to 90% of the analog output when switch is turned ON
t
OFF
Propagation delay measured between 50% of the digital input to 90% of the analog output when switch is turned OFF
BW Frequency response of the switch in the ON state measured at – 3 dB
Unwanted signal coupled from channel to channel. Measured in – dB. X
TALK
= 20 log V
O
/V
I
. This is a nonadjacent
X
TALK
crosstalk.
O
IRR
Off isolation is the resistance (measured in – dB) between the input and output with the switch OFF.
Magnitude variation between analog input and output pins when the switch is ON and the dc offset of composite-video
D
G
signal varies at the analog input pin. In the NTSC standard, the frequency of the video signal is 3.58 MHz, and dc offset
is from 0 to 0.714 V.
Phase variation between analog input and output pins when the switch is ON and the dc offset of composite-video signal
D
P
varies at the analog input pin. In the NTSC standard, the frequency of the video signal is 3.58 MHz, and dc offset is from
0 to 0.714 V.
I
CC
Static power-supply current
I
CCD
Variation of I
CC
for a change in frequency in the control ( EN, IN) inputs
Δ I
CC
This is the increase in supply current for each control input that is at the specified voltage level, rather than V
CC
or GND.
Copyright © 2004 – 2009, Texas Instruments Incorporated Submit Documentation Feedback 3
Product Folder Link(s): TS5V330