Datasheet

TS5V330C
www.ti.com SCDS276B –APRIL 2009–REVISED DECEMBER 2009
PARAMETER DEFINITIONS
PARAMETER DESCRIPTION
r
ON
Resistance between the D and S ports with the switch in the ON-state
I
OZ
Output leakage current measured at the D and S ports with the switch in the OFF-state
I
OS
Short circuit current measured at the I/O pins.
V
IN
Voltage at the IN pin
V
EN
Voltage at the EN pin
C
IN
Capacitance at the control inputs (EN, IN)
C
OFF
Capacitance at the analog I/O port when the switch is OFF
C
ON
Capacitance at the analog I/O port when the switch is ON
V
IH
Minimum input voltage for logic high for the control inputs (EN, IN)
V
IL
Minimum input voltage for logic low for the control inputs (EN, IN)
V
H
Hysteresis voltage at the control inputs (EN, IN)
V
IK
I/O and control inputs diode clamp voltage (EN, IN)
V
I
Voltage applied to the D or S pins when D or S is the switch input.
V
O
Voltage applied to the D or S pins when D or S is the switch output.
I
IH
Input high leakage current of the control inputs (EN, IN)
I
IL
Input low leakage current of the control inputs (EN, IN)
I
I
Current into the D or S pins when D or S is the switch input.
I
O
Current into the D or S pins when D or S is the switch output.
I
off
Output leakage current measured at the D and S ports with V
CC
= 0
Propagation delay measured between 50% of the digital input to 90% of the analog output when switch is turned
t
ON
ON.
Propagation delay measured between 50% of the digital input to 90% of the analog output when switch is turned
t
OFF
OFF.
BW Frequency response of the switch in the ON-state measured at –3 dB
Unwanted signal coupled from channel to channel. Measured in –dB. X
TALK
= 20 LOG V
OUT
/V
IN
. This is a
X
TALK
non-adjacent crosstalk.
O
IRR
Off-isolation is the resistance (measured in –dB) between the input and output with the switch OFF.
Magnitude variation between analog input and output pins when the switch is ON and the DC offset of composite
D
G
video signal varies at the analog input pin. In NTSC standard the frequency of the video signal is 3.58 MHz and
DC offset is from 0 to 0.714 V.
Phase variation between analog input and output pins when the switch is ON and the DC offset of composite
D
P
video signal varies at the analog input pin. In NTSC standard the frequency of the video signal is 3.58 MHz and
DC offset is from 0 to 0.714 V.
I
CC
Static power supply current
I
CCD
Variation of I
CC
for a change in frequency in the control inputs (EN, IN)
This is the increase in supply current for each control input that is at the specified voltage level, rather than V
CC
or
ΔI
CC
GND.
Copyright © 2009, Texas Instruments Incorporated Submit Documentation Feedback 3
Product Folder Link(s): TS5V330C