Datasheet

ManualsBrandsTEXAS INSTRUMENTS ManualsInterface ICsInterface IC - analogue switches TSSOP 20



    

   

SCDS163A − MAY 2004 − REVISED MAY 2004

POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

D Wide Bandwidth (BW = 300 MHz Min)

D Low Differential Crosstalk

TALK

= −60 dB Typ)

D Low Power Consumption (I

= 3 mA Max)

D Bidirectional Data Flow, With Near-Zero

Propagation Delay

D Low ON-State Resistance (r

= 3 W Typ)

D V

Operating Range From 6 V to 6.5 V

D I

off

Supports Partial-Power-Down Mode

Operation

D Data and Control Inputs Provide

Undershoot Clamp Diode

D Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

D ESD Performance Tested Per JESD 22

− 2000-V Human-Body Model

(A114-B, Class II)

− 1000-V Charged-Device Model (C101)

D Suitable for Both 10 Base-T/100 Base-T

Signaling

D OR DBQ PACKAGE

(TOP VIEW)

GND

PW PACKAGE

(TOP VIEW)

RGY PACKAGE

(TOP VIEW)

116

GND

NC − No internal connection

description/ordering information

The TI TS5L100 LAN switch is a 4-bit 1-of-2 multiplexer/demultiplexer with a single switch-enable (E) input.

When E

is low, the switch is enabled and the I port is connected to the Y port. When E is high, the switch is

disabled and the high-impedance state exists between the I and Y ports. The select (S) input controls the data

path of the multiplexer/demultiplexer.

ORDERING INFORMATION

PACKAGE

†

ORDERABLE

PART NUMBER

TOP-SIDE

MARKING

QFN − RGY Tape and reel TS5L100RGYR TG100

SOIC − D

Tube TS5L100D

TS5L100

0°C to 70°C

SOIC − D

Tape and reel TS5L100DR

TS5L100

0°C to 70°C

SSOP (QSOP) − DBQ Tape and reel TS5L100DBQR TG100

TSSOP − PW

Tube TS5L100PW

TG100

TSSOP − PW

Tape and reel TS5L100PWR

TG100

†

Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines

are available at www.ti.com/sc/package.

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of

Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

    !"   #!$% &"'

&!   #" #" (" "  ") !"

&& *+' &! #", &"  ""%+ %!&"

",  %% #""'

Summary of content (26 pages)

PAGE 1
SCDS163A − MAY 2004 − REVISED MAY 2004 D Wide Bandwidth (BW = 300 MHz Min) D Low Differential Crosstalk D Data and Control Inputs Provide D (XTALK = −60 dB Typ) D Low Power Consumption (ICC = 3 mA Max) D Bidirectional Data Flow, With Near-Zero D Propagation Delay Low ON-State Resistance (ron = 3 W Typ) VCC Operating Range From 6 V to 6.
PAGE 2
SCDS163A − MAY 2004 − REVISED MAY 2004 description/ordering information (continued) This device can be used to replace mechanical relays in LAN applications. This device has low ron, wide bandwidth, and low differential crosstalk, making it suitable for 10 Base-T, 100 Base-T, and various other LAN applications. This device is fully specified for partial-power-down applications using Ioff.
PAGE 3
SCDS163A − MAY 2004 − REVISED MAY 2004 logic diagram (positive logic) 2 4 IA0 YA 3 IA1 YB 7 5 IB0 6 IB1 9 11 YC 10 YD 12 14 13 S IC0 IC1 ID0 ID1 1 15 Control Logic E POST OFFICE BOX 655303 • DALLAS, TEXAS 75265 3
PAGE 4
SCDS163A − MAY 2004 − REVISED MAY 2004 absolute maximum ratings over operating free-air temperature range (unless otherwise noted)† Supply voltage range, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −0.5 V to 7 V Control input voltage range, VIN (see Notes 1 and 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −0.
PAGE 5
SCDS163A − MAY 2004 − REVISED MAY 2004 electrical characteristics over recommended VCC = 6 V to 6.5 V (unless otherwise noted) PARAMETER VIK Vhys E, S operating free-air TEST CONDITIONS VCC = 6 V, IIN = −18 mA E = low, temperature range, TYP† MAX UNIT −1.8 V MIN E, S 150 VO IIH E, S VI = 4.5 V, VCC = 6.5 V, IIL E, S VCC = 6.5 V, RL = 100 Ω, see Figure 11 3.7 mV 4.
PAGE 6
SCDS163A − MAY 2004 − REVISED MAY 2004 OPERATING CHARACTERISTICS 6 50 45 5 25°C 70°C 40 ron − ON Resistance − Ω 4 30 25 3 VO 20 2 25°C 70°C 15 10 1 ron 5 0 0 0 1 2 3 4 VI − Input Voltage − V Figure 1.
PAGE 7
SCDS163A − MAY 2004 − REVISED MAY 2004 OPERATING CHARACTERISTICS 6 50 45 5 ron − ON Resistance − Ω 35 4 30 25 3 VO 20 VO − Output Voltage − V 40 2 15 10 ron 1 5 0 0 0 1 2 3 VI − Input Voltage − V 4 5 6 Figure 2. ron and VO vs VI (VCC = 6.
PAGE 8
SCDS163A − MAY 2004 − REVISED MAY 2004 OPERATING CHARACTERISTICS 0 0 −5 −1 Phase −10 Gain −3 −15 −20 Gain − dB −4 −25 −5 −30 −6 −35 −7 −40 −8 −45 −9 1 10 100 Frequency − MHz Gain −3 dB at 501.2 MHz Phase at −3-dB Frequency, −31.7 Degrees Figure 3.
PAGE 9
SCDS163A − MAY 2004 − REVISED MAY 2004 OPERATING CHARACTERISTICS 0 250 −10 200 150 −20 100 50 −40 0 −50 −50 −60 Phase − Deg Off Isolation − dB Phase −30 −100 Off Isolation −70 −150 −80 −200 −250 −90 1 10 100 600 Frequency − MHz Off Isolation at 30 MHz, −52.1 dB Phase at 30 MHz, 77 Degrees Figure 4.
PAGE 10
SCDS163A − MAY 2004 − REVISED MAY 2004 OPERATING CHARACTERISTICS 3 2.5 2 1.5 VI+ VI− 1 0.5 0 Voltage − V 0.01 0.005 Differential Crosstalk 0 −0.005 −0.01 0.04 0.03 0.02 0.01 0 −0.01 −0.02 −0.03 −0.04 −0.05 23 VO+ VO− 43 63 83 Time − ns Figure 6.
PAGE 11
SCDS163A − MAY 2004 − REVISED MAY 2004 PARAMETER MEASUREMENT INFORMATION VCC Input Generator VS 50 Ω S 50 Ω VG1 IX0 DUT VX0 D IX1 VO CL (see Note A) E RL VX1 TEST VCC RL CL VX0 VX1 tON 6.2 V 6.2 V 100 Ω 100 Ω 35 pF 35 pF GND 4.5 V 4.5 V GND tOFF 6.2 V 6.2 V 100 Ω 100 Ω 35 pF 35 pF GND 4.5 V 4.
PAGE 12
SCDS163A − MAY 2004 − REVISED MAY 2004 PARAMETER MEASUREMENT INFORMATION EXT TRIGGER BIAS Network Analyzer (HP8753ES) VBIAS P1 P2 VCC IA0 YA RL = 100 Ω S DUT VS E VE Figure 8. Test Circuit for Frequency Response (BW) Frequency response is measured at the output of the ON channel. For example, when VS = 0, VE = 0, and YA is the input, the output is measured at IA0. All unused analog I/O ports are left open.
PAGE 13
SCDS163A − MAY 2004 − REVISED MAY 2004 PARAMETER MEASUREMENT INFORMATION EXT TRIGGER BIAS Network Analyzer (HP8753ES) VBIAS P1 P2 VCC YA IA0 RL = 100 Ω S 50 Ω† VS E DUT VE IB0 YB RL = 100 Ω † A 50-Ω termination resistor is needed for the network analyzer. Figure 9. Test Circuit for Crosstalk (XTALK) Crosstalk is measured at the output of the nonadjacent ON channel.
PAGE 14
SCDS163A − MAY 2004 − REVISED MAY 2004 PARAMETER MEASUREMENT INFORMATION EXT TRIGGER BIAS Network Analyzer (HP8753ES) VBIAS P1 P2 VCC IA0 YA RL = 100 Ω S DUT VS IA1 E RL = 100 Ω 50 Ω† VE † A 50-Ω termination resistor is needed for the network analyzer. Figure 10. Test Circuit for Off Isolation (OIRR) Off isolation is measured at the output of the OFF channel.
PAGE 15
SCDS163A − MAY 2004 − REVISED MAY 2004 PARAMETER MEASUREMENT INFORMATION Switch ON VI = 4.5 V VO M1 EN† RL = 100 Ω Switch ON M2 EN† † EN is the internal enable signal applied to the switch. NOTE A: ron (M1) and ron (M2) are calculated from the voltage drop and current across the two terminals of M1 and M2, respectively. Figure 11. Test Circuit for VO and ron VCC = 6.2 V 0.
PAGE 16
PACKAGE OPTION ADDENDUM www.ti.
PAGE 17
PACKAGE OPTION ADDENDUM www.ti.com 16-Aug-2012 PREVIEW: Device has been announced but is not in production. Samples may or may not be available. OBSOLETE: TI has discontinued the production of the device. (2) Eco Plan - The planned eco-friendly classification: Pb-Free (RoHS), Pb-Free (RoHS Exempt), or Green (RoHS & no Sb/Br) - please check http://www.ti.com/productcontent for the latest availability information and additional product content details.
PAGE 18
PACKAGE MATERIALS INFORMATION www.ti.com 14-Jul-2012 TAPE AND REEL INFORMATION *All dimensions are nominal Device Package Package Pins Type Drawing SPQ Reel Reel A0 Diameter Width (mm) (mm) W1 (mm) B0 (mm) K0 (mm) P1 (mm) W Pin1 (mm) Quadrant TS5L100DR SOIC D 16 2500 330.0 16.4 6.5 10.3 2.1 8.0 16.0 Q1 TS5L100PWR TSSOP PW 20 2000 330.0 16.4 6.95 7.1 1.6 8.0 16.
PAGE 19
PACKAGE MATERIALS INFORMATION www.ti.com 14-Jul-2012 *All dimensions are nominal Device Package Type Package Drawing Pins SPQ Length (mm) Width (mm) Height (mm) TS5L100DR SOIC D 16 2500 333.2 345.9 28.6 TS5L100PWR TSSOP PW 20 2000 367.0 367.0 38.
PAGE 20
PAGE 21
PAGE 22
PAGE 23
PAGE 24
PAGE 25
PAGE 26
IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue. Buyers should obtain the latest relevant information before placing orders and should verify that such information is current and complete.