Datasheet


W   
SCDS174B − AUGUST 2004 – REVISED MAY 2005
www.ti.com
2
ORDERING INFORMATION
T
A
PACKAGE
(1)
ORDERABLE PART NUMBER TOP-SIDE MARKING
(2)
−40°C to 85°C
SOT (SOT-23) − DBV Tape and reel TS5A3159DBVR JA8_
−40
°
C to 85
°
C
SOT (SC-70) − DCK
(2)
Tape and reel TS5A3159DCKR JA_
(1)
Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are available at www.ti.com/sc/package.
(2)
DBV/DCK: The actual top-side marking has one additional character that designates the assembly/test site.
Absolute Maximum Ratings
(1)
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
+
Supply voltage range
(2)
−0.5 6.5 V
V
NO
, V
COM
Analog voltage range
(2)(3)(4)
−0.5 V
+
+ 0.5 V
I
I/OK
Analog port diode current V
NO
, V
COM
< 0 or V
NO
, V
COM
> V
+
±50 mA
I
NO
, I
COM
ON−state switch current V
NO
, V
COM
= 0 to V
+
±200 mA
ON−state peak switch current
(5)
±400 mA
V
IN
Digital input voltage range
(2)(3)
−0.5 6.5 V
I
IK
Digital input clamp current V
IN
< 0 −50 mA
Continuous current through V
+
or GND ±100 mA
θ
JA
Package thermal impedance
(6)
165 °C
T
stg
Storage temperature range −65 150 °C
(1)
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2)
All voltages are with respect to ground, unless otherwise specified.
(3)
The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(4)
This value is limited to 5.5 V maximum.
(5)
Pulse at 1 ms duration < 10% duty cycle.
(6)
The package thermal impedance is calculated in accordance with JESD 51-7.