Datasheet
www.ti.com
Absolute Minimum and Maximum Ratings
(1) (2)
TS5A3157
10- Ω SPDT ANALOG SWITCH
SCDS219A – NOVEMBER 2005 – REVISED OCTOBER 2007
ORDERING INFORMATION
T
A
PACKAGE
(1)
ORDERABLE PART NUMBER TOP-SIDE MARKING
(2)
NanoFree™ – WCSP (DSBGA)
0.23-mm Large Bump – YZP Tape and reel TS5A3157YZPR _ _ _JC_
(Pb-free)
– 40 ° C to 85 ° C
SOT (SOT-23) – DBV Tape and reel TS5A3157DBVR JC5_
SOT (SC-70) – DCK Tape and reel TS5A3157DCKR JC_
(1) Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are available at
www.ti.com/sc/package.
(2) DBV/DCK: The actual top-side marking has one additional character that designates the assembly/test site.
YZP: The actual top-side marking has three preceding characters to denote year, month, and sequence code, and one following
character to designate the assembly/test site. Pin 1 identifier indicates solder-bump composition (1 = SnPb, • = Pb-free).
FUNCTION TABLE
NC TO COM, NO TO COM,
IN
COM TO NC COM TO NO
L ON OFF
H OFF ON
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
+
Supply voltage range
(3)
– 0.5 6.5 V
V
NO
V
NC
Analog voltage range
(3) (4) (5)
– 0.5 V
+
+ 0.5 V
V
COM
I
K
Analog port diode current V
NC
, V
NO
, V
COM
< 0 or V
NO
, V
NC
, V
COM
> V
+
– 50 50 mA
I
NO
I
NC
On-state switch current V
NC
, V
NO
, V
COM
= 0 to V
+
– 50 50 mA
I
COM
V
I
Digital input voltage range
(3) (4)
– 0.5 6.5 V
I
IK
Digital input clamp current V
I
< 0 – 50 mA
I
+
Continuous current through V
+
– 100 100 mA
I
GND
Continuous current through GND – 100 100 mA
DBV package 206
θ
JA
Package thermal impedance
(6)
DCK package 252 ° C/W
YZP package 132
T
stg
Storage temperature range – 65 150 ° C
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those specified is not implied.
(2) The algebraic convention, whereby the most negative value is a minimum and the most positive value is a maximum
(3) All voltages are with respect to ground, unless otherwise specified.
(4) The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(5) This value is limited to 5.5 V maximum.
(6) The package thermal impedance is calculated in accordance with JESD 51-7.
2 Submit Documentation Feedback Copyright © 2005 – 2007, Texas Instruments Incorporated
Product Folder Link(s): TS5A3157