Datasheet


 W   
 
SCDS183A – JANUARY 2005 – REVISED APRIL 2006
www.ti.com
2
ORDERING INFORMATION
T
A
PACKAGE
(1)
ORDERABLE PART NUMBER TOP-SIDE MARKING
(2)
NanoStar − WCSP (DSBGA)
0.23-mm Large Bump − YEP
Tape and reel
TS5A2053YEPR
−40°C to 85°C
NanoFree − WCSP (DSBGA)
0.23-mm Large Bump − YZP (Pb-free)
Tape and reel
TS5A2053YZPR
SSOP − DCT Tape and reel TS5A2053DCTR JAF_ _ _
VSSOP − DCU Tape and reel TS5A2053DCUR JAF_
(1)
Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are available at www.ti.com/sc/package.
(2)
DCT: The actual top-side marking has three additional characters that designate the year, month, and assembly/test site.
DCU: The actual top-side marking has one additional character that designates the assembly/test site.
YEP/YZP: The actual top-side marking has three preceding characters to denote year, month, and sequence code, and one following character
to designate the assembly/test site. Pin 1 identifier indicates solder-bump composition (1 = SnPb, • = Pb-free).
Absolute Minimum and Maximum Ratings
(1)(2)
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
+
Supply voltage range
(3)
−0.5 6.5 V
V
NO
V
NC
V
COM
Analog voltage range
(3)(4)(5)
−0.5 V
+
+ 0.5 V
I
K
Analog port diode current V
NC,
V
NO
, V
COM
< 0 or V
NO,
V
NC
, V
COM
> V
+
−50 50 mA
I
NO
I
NC
I
COM
On-state switch current V
NC
, V
NO
, V
COM
= 0 to V
+
−50 50 mA
V
I
Digital input voltage range
(3)(4)
−0.5 6.5 V
I
IK
Digital input clamp current V
I
< 0 −50 mA
I
+
Continuous current through V
+
100 mA
I
GND
Continuous current through GND −100 mA
(6)
DCT package 220
θ
JA
Package thermal impedance
(6)
DCU package 227
°C/W
θ
JA
Package thermal impedance
(6)
YEP/YZP package 102
C/W
T
stg
Storage temperature range −65 150 °C
(1)
Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may degrade
device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those specified
is not implied.
(2)
The algebraic convention, whereby the most negative value is a minimum and the most positive value is a maximum
(3)
All voltages are with respect to ground, unless otherwise specified.
(4)
The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(5)
This value is limited to 5.5 V maximum.
(6)
The package thermal impedance is calculated in accordance with JESD 51-7.