User's Manual
Table Of Contents
- TRF7970A Evaluation Module (EVM)
- 1 TRF7970A EVM Description
- 2 Using the TRF7970A EVM With PC GUI
- 2.1 USB Driver
- 2.2 TRF7970A EVM GUI Startup
- 2.3 ISO15693 Tab
- 2.3.1 Inventory (Command Code 0x01)
- 2.3.2 Read Single Block (Command Code 0x20)
- 2.3.3 Write Single Block (Command Code 0x21)
- 2.3.4 Lock Block (Command Code 0x22)
- 2.3.5 Read Multiple Blocks (Command Code 0x23)
- 2.3.6 Write Multiple Blocks (Command Code 0x24)
- 2.3.7 Stay Quiet (Command Code 0x02)
- 2.3.8 Select (Command Code 0x25)
- 2.3.9 Reset to Ready (Command Code 0x26)
- 2.3.10 Write AFI (Command Code 0x27)
- 2.3.11 Lock AFI (Command Code 0x28)
- 2.3.12 Write DSFID (Command Code 0x29)
- 2.3.13 Lock DSFID (Command Code 0x2A)
- 2.3.14 Get System Information (Command Code 0x2B)
- 2.3.15 Get Multiple Block Security Status (Command Code 0x2C)
- 2.3.16 TI Custom Commands
- 2.4 ISO14443A Tab
- 2.5 ISO14443B Tab
- 2.6 FeliCa Tab
- 2.7 Find Tags Tab
- 2.8 Registers Tab
- 2.9 NFC-PP Tab
- 2.10 Test Tab
- 3 Abbreviations
- 4 References
For EVMs annotated as FCC – FEDERAL COMMUNICATIONS COMMISSION Part 15 Compliant
Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC Interference Statement for Class A EVM devices
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
FCC Interference Statement for Class B EVM devices
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
SSZZ027 December 2011