User's Manual
Table Of Contents
- TRF7970A Evaluation Module (EVM)
- 1 TRF7970A EVM Description
- 2 Using the TRF7970A EVM With PC GUI
- 2.1 USB Driver
- 2.2 TRF7970A EVM GUI Startup
- 2.3 ISO15693 Tab
- 2.3.1 Inventory (Command Code 0x01)
- 2.3.2 Read Single Block (Command Code 0x20)
- 2.3.3 Write Single Block (Command Code 0x21)
- 2.3.4 Lock Block (Command Code 0x22)
- 2.3.5 Read Multiple Blocks (Command Code 0x23)
- 2.3.6 Write Multiple Blocks (Command Code 0x24)
- 2.3.7 Stay Quiet (Command Code 0x02)
- 2.3.8 Select (Command Code 0x25)
- 2.3.9 Reset to Ready (Command Code 0x26)
- 2.3.10 Write AFI (Command Code 0x27)
- 2.3.11 Lock AFI (Command Code 0x28)
- 2.3.12 Write DSFID (Command Code 0x29)
- 2.3.13 Lock DSFID (Command Code 0x2A)
- 2.3.14 Get System Information (Command Code 0x2B)
- 2.3.15 Get Multiple Block Security Status (Command Code 0x2C)
- 2.3.16 TI Custom Commands
- 2.4 ISO14443A Tab
- 2.5 ISO14443B Tab
- 2.6 FeliCa Tab
- 2.7 Find Tags Tab
- 2.8 Registers Tab
- 2.9 NFC-PP Tab
- 2.10 Test Tab
- 3 Abbreviations
- 4 References
Initiator GUI File Transfer Being Started Initiator GUI File Transfer Complete
Target GUI File Transfer in Progress
Target File Folder Contents After
File Transfer is Complete (File Received)
Using the TRF7970A EVM With PC GUI
www.ti.com
Figure 37. NFC File Transfer Progress
2.9.6 Card Emulation Mode
For card emulation mode, one TRF7970A EVM should be set up as a Target (see Section 2.9.2). Another
TRF7970A EVM can be used as an RFID reader (in this example, the device is set up and used as an
ISO14443A reader; see Section 2.4).
To use card emulation mode (see Figure 38):
1. On the Initiator reader side, go to the NFC-PP tab.
2. Select the Advanced check box.
3. Click Set Protocol.
4. Click Execute.
5. The SDD and Select commands can now be used.
40
TRF7970A Evaluation Module (EVM) SLOU321– August 2011
Submit Documentation Feedback
Copyright © 2011, Texas Instruments Incorporated