User's Manual
Table Of Contents
- TRF7970A Evaluation Module (EVM)
- 1 TRF7970A EVM Description
- 2 Using the TRF7970A EVM With PC GUI
- 2.1 USB Driver
- 2.2 TRF7970A EVM GUI Startup
- 2.3 ISO15693 Tab
- 2.3.1 Inventory (Command Code 0x01)
- 2.3.2 Read Single Block (Command Code 0x20)
- 2.3.3 Write Single Block (Command Code 0x21)
- 2.3.4 Lock Block (Command Code 0x22)
- 2.3.5 Read Multiple Blocks (Command Code 0x23)
- 2.3.6 Write Multiple Blocks (Command Code 0x24)
- 2.3.7 Stay Quiet (Command Code 0x02)
- 2.3.8 Select (Command Code 0x25)
- 2.3.9 Reset to Ready (Command Code 0x26)
- 2.3.10 Write AFI (Command Code 0x27)
- 2.3.11 Lock AFI (Command Code 0x28)
- 2.3.12 Write DSFID (Command Code 0x29)
- 2.3.13 Lock DSFID (Command Code 0x2A)
- 2.3.14 Get System Information (Command Code 0x2B)
- 2.3.15 Get Multiple Block Security Status (Command Code 0x2C)
- 2.3.16 TI Custom Commands
- 2.4 ISO14443A Tab
- 2.5 ISO14443B Tab
- 2.6 FeliCa Tab
- 2.7 Find Tags Tab
- 2.8 Registers Tab
- 2.9 NFC-PP Tab
- 2.10 Test Tab
- 3 Abbreviations
- 4 References
Using the TRF7970A EVM With PC GUI
www.ti.com
Figure 30. Setting up TRF7970A EVM as Initiator
2.9.2 Target Setup
To set the second TRF7970A as a Target (Slave) (after connecting on the second PC) (see Figure 31):
1. Click the NFC-PP tab.
2. Check the Target Box in the Protocol Flags section of the GUI window.
3. Click Set Protocol.
Figure 31. Setting up TRF7970A EVM as Target
36
TRF7970A Evaluation Module (EVM) SLOU321– August 2011
Submit Documentation Feedback
Copyright © 2011, Texas Instruments Incorporated