User's Manual

TI PROPRIETARY T E X A S I N S T R U M E N T S
INFORMATION -
Revision:
INTERNAL DATA R F I D SYSTEMS 0
S P E C I F I C A T I O N
Page 20 of 25
xx-xx-xx-xxx
Printed copies are not controlled documents - verify the correct revision before use.
REGULATORY COMPLIANCE INFORMATION
As noted in the EVM User’s Guide and/or EVM itself, this EVM and/or
accompanying hardware may or may not be subject to the Federal
Communications Commission (FCC) and Industry Canada (IC) rules.
For EVMs not subject to the above rules, this evaluation board/kit/module is
intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION
OR EVALUATION PURPOSES ONLY and is not considered by TI to be a
finished end product fit for general consumer use. It generates, uses, and can
radiate radio frequency energy and has not been tested for compliance with the
limits of computing devices pursuant to part 15 of FCC or ICES-003 rules,
which are designed to provide reasonable protection against radio frequency
interference. Operation of the equipment may cause interference with radio
communications, in which case the user at his own expense will be required to
take whatever measures may be required to correct this interference.
General Statement for EVMs including a radio
User Power/Frequency Use Obligations: This radio is intended for
development/professional use only in legally allocated frequency and power
limits. Any use of radio frequencies and/or power availability of this EVM and
its development application(s) must comply with local laws governing radio
spectrum allocation and power limits for this evaluation module. It is the
user’s sole responsibility to only operate this radio in legally acceptable
frequency space and within legally mandated power limitations. Any
exceptions to this is strictly prohibited and unauthorized by Texas Instruments
unless user has obtained appropriate experimental/development licenses from
local regulatory authorities, which is responsibility of user including its
acceptable authorization.