Datasheet

Schematic and Bill of Materials

www.ti.com

6.2 Bill of Materials

Table 2. Bill of Materials

Count RefDes Value Description Size Part No. MFR

2 C1, C2 10µF Capacitor, Ceramic, 10V, X7R, 10% 0805 Std Std

2 C3, C4 0.47µF Capacitor, Ceramic, 16V, X7R, 10% 0603 Std Std

0 J1, J2 142-0711-821 CONNECTOR, SHIELDED, END LAUNCH JACK, GOLD 0.250 SQ 142-0711-821 STD

PLATED, FOR 0.062 PCB, EDGE MOUNTED

4 J3, J4, ED550/2DS Terminal Block, RA 2-pin, 6-A, 3.5mm 7.0 x 8.2 mm ED550/2DS OST

J7, J8

1 J5 PEC03SAAN Header, Male 3-pin, 100mil spacing 0.100 inch x 3 PEC03SAAN Sullins

1 J6 PEC04DAAN Header, Male 2x4-pin, 100mil spacing 0.20 x 0.40 inch PEC04DAAN Sullins

1 R1 12.4k Resistor, Chip, 1/16W, 1% 0603 Std Std

1 R2 21.5k Resistor, Chip, 1/16W, 1% 0603 Std Std

1 R3 25.5k Resistor, Chip, 1/16W, 1% 0603 Std Std

1 R4 30.9k Resistor, Chip, 1/16W, 1% 0603 Std Std

1 R5 10k Resistor, Chip, 1/16W, 1% 0603 Std Std

1 TP1 5010 Test Point, Red, Thru Hole 0.125 x 0.125 inch 5010 Keystone

1 TP2 5013 Test Point, Orange, Thru Hole 0.125 x 0.125 inch 5013 Keystone

1 TP3 5011 Test Point, Black, Thru Hole 0.125 x 0.125 inch 5011 Keystone

1 U1 TPS7A8101DRB IC, Low Noise, High-Bandwidth PSRR LDO 1A Linear DRB-8 TPS7A8101DRB TI

Regulator

1 – PCB, 2 In x 2 In x 0.62 In PWR093 Any

2 15-29-1025 Shunt, 2 pos 0.100 In Gold 15-29-1025 Molex

Notes: 1. These assemblies are ESD sensitive, ESD precautions shall be observed.

2. These assemblies must be clean and free from flux and all contaminants. Use of no clean flux is not acceptable..

3. These assemblies must comply with workmanship standards IPC-A-610 Class 2.

4. Ref designators marked with an asterisk ('**') cannot be substituted. All other components can be substituted with equivalent MFG's components.

TPS7A8101EVM Evaluation Module SLVU600– December 2011

Submit Documentation Feedback