Datasheet

TPS7A6201-Q1
SLVSAA0B –NOVEMBER 2010–REVISED MARCH 2012 www.ti.com
ORDERING INFORMATION
(1)
PACKAGE TOP SIDE MARKING ORDERABLE PART NUMBER
(2)
5 pin KTT Reel of 500 7A6201Q1 TPS7A6201QKTTRQ1
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
web site at www.ti.com.
(2) Package drawings, thermal data, and symbolization are available at www.ti.com/packaging.
ABSOLUTE MAXIMUM RATINGS
(1)
over operating free-air temperature range (unless otherwise noted)
NO. DESCRIPTION VALUE UNIT
V
IN
,
1.1 Unregulated inputs
(2)
-0.3 to 45 V
V
EN
1.2 V
OUT
Regulated output 7 V
1.3 V
FB
Feedback voltage -0.3 to 7 V
1.4 θ
JP
Thermal impedance junction to exposed pad KTT (D2PAK) package 10.4 °C/W
1.5 θ
JA
Thermal impedance junction to ambient KTT (D2PAK) package
(3)
30.2 °C/W
1.6 θ
JA
Thermal impedance junction to ambient KTT (D2PAK) package
(4)
34.4 °C/W
1.7 ESD Electrostatic discharge (Human Body Model)
(5)
2 kV
1.8 T
OP
Operating ambient temperature -40 to +125 °C
1.9 T
S
Storage temperature range -65 to +150 °C
1.10 T
LEAD
Lead temperature (soldering, 10sec) 260 °C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. All voltage
values are with respect to GND.
(2) Absolute maximum voltage for duration less than 480ms.
(3) The thermal data is based on JEDEC standard high K profile – JESD 51-5. The copper pad is soldered to the thermal land pattern. Also
correct attachment procedure needs to be incorporated.
(4) The thermal data is based on JEDEC standard low K profile – JESD 51-3. The copper pad is soldered to the thermal land pattern. Also
correct attachment procedure needs to be incorporated.
(5) Tested in accordance with JEDEC Standard 22, Test Method A114-A (100pF capacitor discharged through a 1.5kΩ resistor into each
pin).
DISSIPATION RATINGS
T
A
< 25°C POWER DERATING FACTOR T
A
= 85°C POWER
NO. JEDEC STANDARD PACKAGE
RATING (W) ABOVE T
A
= 25°C (°C/W) RATING (W)
JEDEC Standard
2.1 5 pin KTT 3.63 34.4 1.89
PCB - low K, JESD 51-3
JEDEC Standard
2.2 5 pin KTT 4.14 30.2 2.15
PCB - high K, JESD 51-5
RECOMMENDED OPERATING CONDITIONS
NO. DESCRIPTION MIN MAX UNIT
3.1 V
IN
, V
EN
Unregulated input voltage 4 40 V
3.2 T
J
Operating junction temperature range -40 150 °C
2 Copyright © 2010–2012, Texas Instruments Incorporated