Datasheet

2-1
EVM Adjustments and Test Points
EVM Adjustments and Test Points
This chapter explains the following four EVM adjustment modes:
Adjustment by switch
Adjustment by jumper
Adjustment by trimmer
Adjustment by programming header
Figure 2–1 shows the locations of the adjustment points on the board.
Topic Page
2.1 Adjustment by Switch 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2 Adjustment by Jumper 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.3 Adjustment by Trimmer 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.4 Adjustment by Programming Header 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . .
2.5 Test Setup 2–3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 2