Datasheet

www.ti.com
Input Voltage (IN)
Output Voltage (OUTPUT)
ABSOLUTE MAXIMUM RATINGS
DISSIPATION RATING TABLE
RECOMMENDED OPERATING CONDITIONS
TPS75901, TPS75915
TPS75918, TPS75925, TPS75933
SLVS318E – DECEMBER 2000 – REVISED MARCH 2004
The V
IN
terminal is an input to the regulator.
The V
OUTPUT
terminal is an output to the regulator.
over operating junction temperature range (unless otherwise noted)
(1)
TPS759XX
Input voltage range
(2)
V
I
-0.3 V to 6 V
Voltage range at EN -0.3 V to 6 V
Maximum PG voltage (TPS759xx) 6 V
Peak output current Internally limited
Continuous total power dissipation See Dissipation Rating Table
Output voltage V
O
(OUTPUT, FB) 5.5 V
Operating junction temperature range T
J
-40°C to 150°C
Storage temperature range T
stg
-65°C to 150°C
ESD rating HBM 2 kV
CDM 500 V
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values are with respect to network terminal ground.
PACKAGE R
ΘJC
(°C/W) R
ΘJA
(°C/W)
(1)
TO-220 2 58.7
(2)
TO-263 2 38.7
(3)
(1) For both packages, the R
ΘJA
values were computed using JEDEC
high K board (2S2P) with 1 ounce internal copper plane and ground
plane. There was no air flow across the packages.
(2) R
ΘJA
was computed assuming a vertical, free standing TO-220
package with pins soldered to the board. There is no heatsink
attached to the package.
(3) R
ΘJA
was computed assuming a horizontally mounted TO-263
package with pins soldered to the board. There is no copper pad
underneath the package.
MIN MAX UNIT
V
I
(1)
Input voltage 2.8 5.5 V
V
O
Output voltage range 1.22 5 V
I
O
Output current 0 7.5 A
T
J
Operating virtual junction temperature -40 125 °C
(1) To calculate the minimum input voltage for your maximum output current, use the following equation: V
I(min)
= V
O(max)
+ V
DO(max load)
.
5