Datasheet

Bill of Materials
1-5
Introduction
1.5 Bill of Materials
Table 1–3 lists materials required for the TPS75525 EVMs.
Table 1–3.TPS75525EVM Bill of Materials
Qty Ref Des Description Size MFR Part Number
3 C1, C4, C5 Capacitor, tantalum, 100 µF, 10 V, 20% 7343 (D) Sprague 293D107X0010D2T
2 C2, C3 Capacitor, ceramic, 1-µF, 16 V, X7R, 10% 805 Murata GRM40X7R105K16
1 D1 Diode, Schottky, 8.0-A, 35 V TO-252AA On Semi MBRD835L
1 J1 Terminal block, 2 pin, 15 A, 5,1 mm 148830 OST ED1609
1 J2 Terminal block, 3 pin, 15 A, 5,1 mm 221430 OST ED1610
2 JP1, JP2 Header, 2 pin, 100 mil spacing, (36-pin strip) 0.100 × 2 Sullins PTC36SAAN
2 JP3, JP4 Header, 3 pin, 100 mil spacing, (36-pin strip) 0.100 × 3 Sullins PTC36SAAN
4 R1, R2, R3, R6 Resistor, chip, 100 kΩ, 1/10 W, 1% 805 Std Std
0 R4, R5 805 — —
6 TP1, TP2,
TP4 – TP7
Test point, red, 1 mm 0.038 Farnell 240–345
2 TP3, TP8 Test point, black, 1 mm 0.038 Farnell 240–333
1 U1 IC, voltage regulator, LDO, 2.5 V, 5 A 267750 TI TPS75525KTT
1 U2 IC, voltage regulator, LDO, 3.3 V, 5 A 267750 TI TPS75733KTT
4 — Shunt, 100 mil, black 0.1 3M 929950–00
1 — PCB, 2.7 in × 2.59 in × 0.062 in Any SLVP190
1.6 Board Layout
Figures 1–2 and 1-3 show the board layout for the TPS75525EVM
Figure 1–2. Top Layer