Datasheet

www.ti.com

Bill of Materials

6 Bill of Materials

Table 3. Bill of Materials

HPA713-001 HPA713-002

Count Count RefDes Value Description Size Part Number MFR

2 2 C1, C4 10 µF Capacitor, Ceramic,10V, X5R 20% 0805 STD STD

0 0 C2 DNI Capacitor, Ceramic 0603 STD STD

1 1 C3 1 µF Capacitor, Ceramic, 6.3V, X5R, 10% 0805 STD STD

0 0 C5 DNI Capacitor, Ceramic 6032 STD STD

6 6 J1, J2, J3, J4, J5, J6 PEC02SAAN Header, Male 2-pin, 100mil spacing 0.100 inch x 2 PEC02SAAN Sullins

0 1 JP1 PEC03SAAN Header, Male 3-pin, 100mil spacing 0.100 inch x 3 PEC03SAAN Sullins

1 0 R1 1.91K Resistor, Chip, 1/16W, 1% 0603 STD STD

1 0 R2 2.87K Resistor, Chip, 1/16W, 1% 0603 STD STD

1 0 U1 TPS74001DPT IC, 1.5A Low Voltage LDO Regulator with Dual Input PVSON TPS74001DPT TI

Voltages

0 1 U1 TPS74012DPT IC, 1.5A Low Voltage LDO Regulator with Dual Input PVSON TPS74012DPT TI

Voltages

Notes: 1. These assemblies are ESD sensitive, ESD precautions shall be observed.

2. These assemblies must be clean and free from flux and all contaminants. Use of no clean flux is not acceptable.

3. These assemblies must comply with workmanship standards IPC-A-610 Class 2.

4. Ref designators marked with an asterisk ('**') cannot be substituted. All other components can be substituted with equivalent MFG's components.

5. Install label after final wash. Text shall be 8 pt font. Text shall be per Table 4.

Table 4. Assembly Number and Corresponding

Label Text

ASSEMBLY NUMBER TEXT

HPA713-001 TPS74001DPTEVM-713

HPA713-002 TPS74012DPTEVM-713

SLVU476– June 2011 TPS740xxDPTEVM-713 Evaluation Module

Submit Documentation Feedback