Datasheet
www.ti.com
ABSOLUTE MAXIMUM RATINGS
POWER DISSIPATION RATINGS
TPS71319
TPS71334
SBVS055A – DECEMBER 2004 – REVISED JANUARY 2005
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated
circuits be handled with appropriate precautions. Failure to observe proper handling and installation
procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision
integrated circuits may be more susceptible to damage because very small parametric changes could
cause the device not to meet its published specifications.
ORDERING INFORMATION
(1)
VOLTAGE (T
J
) PACKAGE- SPECIFIED
LEAD TEMPERATURE PACKAGE ORDERING TRANSPORT
PRODUCT V
OUT1
V
OUT2
(DESIGNATOR) RANGE (T
J
) MARKING NUMBER MEDIA, QUANTITY
TPS71319DRCT Tape and Reel, 250
TPS71319 1.8 V Adjustable SON-10 (DRC) -40 ° C to +125 ° C ARP
TPS71319DRCR Tape and Reel, 3000
TPS71334DRCT Tape and Reel, 250
TPS71334 3.3 V Adjustable SON-10 (DRC) -40 ° C to +125 ° C ARO
TPS71334DRCR Tape and Reel, 3000
(1) For the most current package and ordering information, see the Package Ordering Addendum located at the end of this data sheet.
over operating junction temperature range unless otherwise noted
(1)
TPS713xx UNIT
V
IN
range -0.3 to 6.0 V
V
RESET
range -0.3 to V
IN
+ 0.3 V
V
EN1
, V
EN2
range -0.3 to V
IN
+ 0.3 V
V
OUT
range -0.3 to 6.0 V
Peak output current Internally limited
Output short-circuit duration Indefinite
Continuous total power dissipation See Dissipation Ratings Table
Junction temperature range, T
J
-40 to +150 ° C
Storage temperature range -65 to +150 ° C
ESD rating, HBM 2 kV
ESD rating, CDM 500 V
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under the Electrical Characteristics
is not implied. Exposure to absolute maximum rated conditions for extended periods may affect device reliability.
DERATING FACTOR T
A
≤ 25 ° C T
A
= 70 ° C T
A
= 85 ° C
BOARD PACKAGE R
θ JC
R
θ JA
ABOVE T
A
= 25 ° C POWER RATING POWER RATING POWER RATING
High-K
(1)
DRC 48 52 19 mW/ ° C 1.92 W 1.06 W 0.77 W
(1) The JEDEC High-K (2s2p) board design used to derive this data was a 3 inch x 3 inch, multilayer board with 1-ounce internal power and
ground planes and 2-ounce copper traces on the top and bottom of the board.
2