Datasheet

Powering Up the EVM - Software Control

www.ti.com

6.2 GPIO/I

C Controls Tab

Use this page to change the I

C interface data rate and SDA/SCL pull-up resistors which are built into the

USB interface adapter.

This tab also provides controls for the VCOM_CTRL, PWRUP, and WAKEUP pins. Please note that the

jumpers JP1, JP2, and JP3 must be removed to control the pins through the GUI.

Figure 5. GPIO/I

C Control Tab

Figure 6. JP1, JP2, and JP3 Must Be Removed Before Using the GUI GPIO Control

SLVU548–October 2011

Submit Documentation Feedback