Datasheet

3 Bill of Materials and Schematic
3.1 Bill of Materials
3.2 Schematic
www.ti.com Bill of Materials and Schematic
Table 2. HPA265 Bill of Materials
COUNT Ref Des Value DESCRIPTION SIZE Part Number MFR
1 C1 10 µ F Capacitor, Ceramic, 10V, X7R, 10% 0805 STD Murata
2 C2, C3 4.7 µ F Capacitor, Ceramic, 10V, X7R, 10% 0805 STD Murata
1 C4 100 nF Capacitor, Ceramic, 10V, X7R 0603 STD Murata
1 J1 PTC36SAAN Header, Male 6-pin, 100mil spacing, (36-pin strip) 0.100 inch × 6 PTC36SAAN Sullins
1 J2, J4 PTC36SAAN Header, Male 4 pin, 100mil spacing, (36-pin strip) 0.100 inch × 4 PTC36SAAN Sullins
1 J3 PTC36SAAN Header, 3-pin, 100 mil spacing, (36-pin strip) 0.100 inch × 3 PTC36SAAN Sullins
1 L1** 4.7 µ H Inductor, SMT, 1.0A, 175m Ω 0.116 × 0.116 inch LPS3008-222ML Coilcraft
1 R1 100 Resistor, Chip, 1/10W, 1% 0805 STD STD
1 R2 162k Resistor, Chip, 1/10W, 1% 0805 STD STD
1 R3 909k Resistor, Chip, 1/10W, 1% 0805 STD STD
1 U1** TPS65136 IC, Single inductor multiple output reg. for AMOLED QFN-16 TPS65136RTE TI
1 -- Shunt, 100 mil, Black 0.100 929950-00 3M
-- PCB HPA265 Any
Notes: 1. These assemblies are ESD sensitive, ESD precautions shall be observed.
2. These assemblies must be clean and free from flux and all contaminants. Use of no clean flux is not acceptable.
3. These assemblies must comply with workmanship standards IPC-A-610 Class 2.
4. Ref designators marked with an asterisk ('**') cannot be substituted.
All other components can be substituted with equivalent MFG's components.
Figure 1. TPS65136EVM Schematic
SLVU244 – June 2008 TPS65136EVM-265 3
Submit Documentation Feedback