Datasheet

www.ti.com
2.2 Setup
2.2.1 EVM Family Configuration
2.2.2 Operation
Setup
The EVM is configured to provide the following nominal operating conditions:
Input voltage: 2.5 V to 6 V
Output voltage: See Table 1
Maximum load current: See Table 2
Table 1. EVM Preset Output Voltage
Output TPS65050EVM TPS65051EVM TPS65052EVM TPS65054EVM TPS65056EVM
VDCDC1 3.3 V 3.3 V 3.3 V 3.3 V 3.3 V
VDCDC2 1.6 V 1.6 V 1 V 1.3 V 1 V
VLDO1 3.3 V 3.3 V 3.3 V 3.3 V 3.3 V
VLDO2 3.3 V 3.3 V 3.3 V 3.3 V 3.3 V
VLDO3 1.85 V 1.2 V 1.85 V 1.85 V 1.85 V
VLDO4 1.85 V 1.2 V 1.85 V 1.85 V 1.3 V
Table 2. Maximum Load Current
Output TPS65050EVM TPS65051EVM TPS65052EVM TPS65054EVM TPS65056EVM
VDCDC1 600 mA 1 A 1 A 600 mA 1 A
VDCDC2 600 mA 600 mA 600 mA 600 mA 600 mA
VLDO1 400 mA 400 mA 400 mA 400 mA 400 mA
VLDO2 400 mA 400 mA 400 mA 400 mA 400 mA
VLDO3 200 mA 200 mA 200 mA 200 mA 200 mA
VLDO4 200 mA 200 mA 200 mA 200 mA 200 mA
1. Configure all EVM jumpers to factory settings shown in Table 3 .
2. Connect the input voltage return to J2.
3. Connect the positive input voltage to J1.
4. Connect all loads to the outputs.
5. Turn on input voltage.
SLVU191A – November 2006 – Revised April 2007 TPS6505xEVM-195 5
Submit Documentation Feedback