Datasheet

22uF
5V / 3A
1 / 2.2 µH
TPS62133
PVIN
AVIN
EN
SS/TR
DEF
FSW
SW
VOS
PG
FB
AGND
PGND
100k
10uF
(5 .. 17)V
3.3nF
0.1uF
TRSSFB
RAV
/
.. ××= m52640
22uF
4.7uF
2.2µH(4 .. 17) V
0.1R187k
ADIM
PVIN
AVIN
EN
SS/TR
DEF
FSW
SW
VOS
PG
FB
AGND
PGND
TPS62130
TPS62130, TPS62130A
TPS62131, TPS62132, TPS62133
SLVSAG7B –NOVEMBER 2011–REVISED JUNE 2013 www.ti.com
Application Example As Power LED Supply
spacing
The TPS62130 can be used as a power supply for power LEDs. The FB pin can be easily set down to lower
values than nominal by using the SS/TR pin. With that, the voltage drop on the sense resistor is low to avoid
excessive power loss. Since this pin provides 2.5µA, the feedback pin voltage can be adjusted by an external
resistor per Equation 15. This drop, proportional to the LED current, is used to regulate the output voltage (anode
voltage) to a proper level to drive the LED. Both analog and PWM dimming are supported with the TPS62130.
Figure 42 shows an application circuit, tested with analog dimming:
spacing
Figure 42. Single Power LED Supply
spacing
The resistor at SS/TR sets the FB voltage to a level of about 300mV and is calculated from Equation 15.
spacing
(15)
spacing
The device now supplies a constant current, set by the resistor at the FB pin, by regulating the output voltage
accordingly. The minimum input voltage has to be rated according the forward voltage needed by the LED used.
More information is available in the Application Note SLVA451.
spacing
Typical Applications
spacing
spacing
Figure 43. 5V/3A Power Supply
spacing
spacing
24 Submit Documentation Feedback Copyright © 2011–2013, Texas Instruments Incorporated
Product Folder Links: TPS62130, TPS62130A TPS62131 TPS62132 TPS62133