Datasheet

TPS62061, TPS62063
TPS62060
SLVSA95A –MARCH 2010– REVISED JANUARY 2011 www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
ORDERING INFORMATION
(1)
FUNCTION
MAXIMUM
PART OUTPUT PACKAGE PACKAGE
T
A
OUTPUT
MODE Power Good
NUMBER VOLTAGE
(2)
DESIGNATOR MARKING
CURRENT
PG
TPS62060 Adjustable Selectable No 1.6 A CGY
TPS62061 1.8V fix Selectable No 1.6 A CGX
–40°C to
DSG
85°C
TPS62063 3.3V fix Selectable No 1.6 A QXD
TPS6206x
(2)
Adjustable no yes 1.6A -
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
website at www.ti.com.
(2) Contact TI for fixed output voltage options / Power Good output options
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range (unless otherwise noted)
(1)
VALUE UNIT
MIN MAX
Voltage Range
(2)
AVIN, PVIN –0.3 7
EN, MODE, FB –0.3 V
IN
+0.3 < 7 V
SW –0.3 7
Current (source) Peak output Internally limited A
Electrostatic Discharge (HBM) QSS 009-105 (JESD22-A114A)
(3)
2
kV
Electrostatic Discharge (CDM) QSS 009-147 (JESD22-C101B.01) 1
Electrostatic Discharge (Machine model) 200 V
T
J
–40 125 °C
Temperature
T
stg
–65 150 °C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values are with respect to network ground terminal.
(3) The human body model is a 100-pF capacitor discharged through a 1.5-kΩ resistor into each pin. The machine model is a 200-pF
capacitor discharged directly into each pin.
DISSIPATION RATINGS
(1)(2)
POWER RATING DERATING FACTOR
PACKAGE R
θJA
T
A
= ≤ 25°C ABOVE T
A
= 25°C
DSG 75°C/W 1300 mW 13 mW/°C
(1) Maximum power dissipation is a function of T
J(max)
, θ
JA
and T
A
. The maximum allowable power dissipation at any allowable ambient
temperature is PD = (T
J(max)
– T
A
)/ θ
JA
.
(2) This thermal data measured with high-K board (4 layers according to JESD51-7 JEDEC Standard.
2 Copyright © 2010–2011, Texas Instruments Incorporated