Datasheet

2-1

Evaluation With the TPS6205xEVM

This chapter details the evaluation process and features of the EVM. For this

purpose, a load is connected to the output pins Vout and GND, which allows

the load current to be adjusted between 0 mA and 800 mA.

For accurate output voltage and input voltage measurements, it is important

to measure the voltage on the input and output voltage terminals with a

voltmeter connected directly to the input voltage or output voltage terminals.

This eliminates any measurement errors related to voltage drops along the

input and output terminal wires connected to the power supply or load.

Topic Page

2.1 Enable (EN) Jumper 2-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.2 Synchronization (SYNC) Jumper 2-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.3 Power Good (PG) Pin 2-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.4 Low Battery Out (LBO) Pin 2-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Chapter 2