Datasheet

2-1

Evaluation With the TPS6200xEVM

This chapter details the evaluation process and features of the EVM. For this

purpose, a load is connected to the output pin VOUT and GND1, which allows

the load current to be adjusted between 0 mA and 600 mA.

For accurate output voltage and input voltage measurements, it is important

to measure the voltage on the input and output voltage terminals with kelvin

contacts or with a voltmeter connected directly to the input voltage or output

voltage terminals. This eliminates any measurement errors related to voltage

drops along the input and output terminal wires connected to the power supply

or load.

The EVM has additional pads to allow the user to assemble an additional

output capacitor, C4, onto the PCB for further evaluation purposes.

Topic Page

2.1 Enable (EN) Jumper 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.2 Synchronization (SYNC) Jumper 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.3 Current Limit (ILIM) Jumper 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.4 Power Good (PG) Pin 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Chapter 2