Datasheet
TPS61080
TPS61081
www.ti.com
SLVS644D –FEBRUARY 2006–REVISED APRIL 2013
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range (unless otherwise noted)
(1)
VALUE UNIT
Supply Voltages on pin VIN
(2)
–0.3 to 7 V
Voltages on pins EN, FB, SS, L and FSW
(2)
–0.3 to 7 V
Voltage on pin OUT
(2)
30V V
Voltage on pin SW
(2)
30V V
Continuous Power Dissipation See Dissipation Rating Table
Operating Junction Temperature Range –40 to 150 °C
Storage Temperature Range –65 to 150 °C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values are with respect to network ground terminal.
DISSIPATION RATINGS
T
A
≤ 25°C T
A
= 70°C T
A
= 85°C
PACKAGE θ
JC
θ
JA
POWER RATING POWER RATING POWER RATING
QFN
(1)
3.21°C/W 270°C/W 370 mW 204 mW 148 mW
QFN
(2)
3.21°C/W 48.7°C/W 2.05 W 1.13 W 821 mW
(1) Soldered PowerPAD™ on a standard 2-layer PCB without vias for thermal pad
(2) Soldered PowerPAD on a standard 4-layer PCB with vias for thermal pad
RECOMMENDED OPERATING CONDITIONS
over operating free-air temperature range (unless otherwise noted)
MIN NOM MAX UNIT
V
IN
Input voltage range 2.5 6.0 V
V
OUT
Output voltage range VIN 27 V
L Inductor
(1)
4.7 10 μH
C
IN
Input capacitor
(1)
1 μF
C
OUT
Output capacitor
(1)
4.7 30 μF
T
A
Operating ambient temperature –40 85 °C
T
J
Operating junction temperature –40 125 °C
(1) Refer to application section for further information
ELECTRICAL CHARACTERISTICS
VIN = 3.6 V, EN = VIN, T
A
= –40°C to 85°C, typical values are at T
A
= 25°C (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
SUPPLY CURRENT
V
IN
Input voltage range 2.5 6.0 V
I
Q
Operating quiescent current into VIN Device switching no load 6 mA
I
SD
Shutdown current EN = GND 1 μA
V
UVLO
Under-voltage lockout threshold V
IN
falling 1.65 1.8 V
V
hys
Under-voltage lockout hysterisis 50 mV
ENABLE
Enable level voltage V
IN
= 2.5 V to 6 V 1.2
V
EN
V
Disable level voltage V
IN
= 2.5 V to 6 V 0.4
R
en
Enable pull down resistor 400 800 1600 kΩ
t
off
EN pulse width to disable EN high to low 74 ms
Copyright © 2006–2013, Texas Instruments Incorporated Submit Documentation Feedback 3
Product Folder Links: TPS61080 TPS61081