Datasheet

Setup of the EVM
2-5
Physical Data and Setup of the EVM
Table 2–2.Pin Assignment of the Board to a 14-Pin Dual-In-Line Socket
Socket Pin Number Connected Signal
1 LBI
2 Not connected
3 OUT
7, 8 GND
12 IN
13 SNOOZE
14 LBO
2.3 Setup of the EVM
Follow these steps for proper operation of the EVM:
1) Connect a load to the output (between GND and OUT).
> 33 Ω or 0 mA to 100 mA for 2.0 V ≤ V
I
≤ 3.6 V
> 66 Ω or 0 mA to 50 mA for 1.8 V ≤ V
I
< 2 V
> 132 Ω or 0 mA to 25 mA for 1.6 V ≤ V
I
≤ 1.8 V
Note:
Start up only with resistive load, not with a current sink.
2) Connect a dc power supply (or a battery pack) with an appropriate voltage
between input (IN), and ground (GND).
1.6 V ≤ V
I
≤ 3.6 V