Datasheet

Layout of the EVM
2-4
2.2 Layout of the EVM
Figure 2–2 and Figure 2–3 show the placement of the components and the
layout of the EVM. The components and all signals are exclusively placed on
the top layer of the PC board. Figure 2–4 shows the actual size of the board.
Figure 2–2. Placement of the Components
C1
C2
C3
C4
R2
C5
R3
R4
R1
IC1
Figure 2–3. Single Layer of the EVM
Figure 2–4. Actual Size of the EVM, 17,9 mm × 10,2 mm
Table 2–1 contains the values and description of the five capacitors and the
four resistors that are placed on the EVM.
The EVM is built to fit into a 14-pin dual in-line socket. However, not all 14 pins
are used. Only pins 1 to 3, 7, 8, and 12 to 14 of a dual in-line socket are used.
Table 2–2 shows the correlation between the dual in-line pin number and the
connected signal of the device on the board.