Datasheet

Setup of the EVM
2-5
Schematic of the EVM
The space required for the IC and the capacitors on the EVM is approximately
15 mm × 16 mm = 240 mm
2
2.2 Setup of the EVM
For proper operation of the EVM, follow these steps:
1) Make sure that the ENABLE input is either properly jumpered or con-
nected to an external source.
2) Connect a load to the output (between GND and Out)
TPS60120: > 16.5 Ω or 0 mA to 200 mA (V
IN
between 2 V and 3.6 V)
> 33 Ω or 0 mA to 100 mA (V
IN
between 1.8 V and 2 V)
TPS60130: > 16.7 Ω or 0 mA to 300 mA (V
IN
between 3 V and 5.4 V)
> 33.4 Ω or 0 mA to 150 mA (V
IN
between 2.7 V and 3 V)
3) Connect a dc power supply (or a battery pack) with an appropriate voltage
between input (In), and ground (GND).
TPS60120: 1.8 V to 3.6 V
TPS60130: 2.7 V to 5.4 V