Datasheet

Setup of the EVM

1-5

TPS60100 and TPS60110 EVM

Figure 1–3. Top Layer of the EVM

Table 1–1 contains the values and description of all 6 capacitors that are

placed on the EVM.

The space needed for the IC and the capacitors on the EVM is around

15 mm × 16 mm = 240 mm

. The capacitors are not optimized for space. They

are optimized for performance. It is possible to use smaller capacitors to opti-

mize the layout for minimum board space. On the EVM, it is also possible to

solder some other capacitors because the pads are bigger than needed for the

given capacitors.

1.4 Setup of the EVM

For proper operation of the EVM, follow these few steps:

1) Check if all five logic signals are properly connected, either jumper or ex-

ternal source.

2) Connect a load to the output (between GND and Out).

TPS60100: 16.5 Ω to ∞Ω or 0 mA to 200 mA

TPS60110: 16.7 Ω to ∞Ω or 0 mA to 300 mA

3) Connect a signal source (or a battery pack) with the appropriate voltage

between the input (In) and ground, GND.

TPS60100: 1.8 V to 3.6 V

TPS60110: 2.7 V to 5.4 V