Datasheet

VO = 0.765 1+

æ ö

ç ÷

è ø

VO = (0.763 + 0.0017 VO) 1+

æ ö

´ ´

ç ÷

è ø

www.ti.com

Modifications

3 Modifications

These evaluation modules are designed to provide access to the features of the TPS54525. Some

modifications can be made to this module.

3.1 Output Voltage Setpoint

To change the output voltage of the EVMs, it is necessary to change the value of resistor R1. Changing

the value of R1 can change the output voltage above 0.765 V. The value of R1 for a specific output

voltage can be calculated using Equation 1 and Equation 2.

For output voltage from 0.76 V to 2.5 V:

(1)

For output voltage over 2.5 V:

(2)

Table 3 lists the R1 values for some common output voltages. For higher output voltages of 1.8 V or

above, a feedforward capacitor (C2) may be required to improve phase margin. Pads for this component

(C2) are provided on the printed-circuit board. Note that the values given in Table 3 are standard values

and not the exact value calculated using Table 3.

Table 3. Output Voltages

Output Voltage R1 R2 C2 L1 C9 + C10 + C11

(V) (kΩ) (kΩ) (pF) (µH) (µF)

1.0 6.81 22.1 1.0 - 1.5 22- 68

1.05 8.25 22.1 1.0 - 1.5 22- 68

1.2 12.7 22.1 1.0 - 1.5 22- 68

1.5 21.5 22.1 1.5 22- 68

1.8 30.1 22.1 5 - 22 1.5 22- 68

2.5 49.9 22.1 5 - 22 2.2 22- 68

3.3 73.2 22.1 5 - 22 2.2 22- 68

5.0 121 22.1 5 - 22 3.3 22- 68

SLVU643–May 2012 TPS54525EVM-608 5.5-A, SWIFT™ Regulator Evaluation Module

Submit Documentation Feedback