Datasheet

V = 200 mV/div (ac coupled)
IN
Time = 1 µs/div
PH = 2 V/div
V = 1 V/div
OUT
Time = 2 ms/div
EN = 2 V/div
V = 5 V/div
IN
SS = 2 V/div
Test Setup and Results www.ti.com
2.8 Input Voltage Ripple
The TPS5432EVM-116 input voltage ripple is shown in Figure 8 . The output current is the rated full load
of 3 A and V
IN
= 5 V. The ripple voltage is measured directly across the input capacitors.
Figure 8. TPS5432EVM-116 Input Ripple
2.9 Powering Up
2.9.1 Power Up Relative to V
IN
The start-up waveform shown in Figure 9 shows start-up is relative to VIN rising. The input voltage is
initially applied, and when the input reaches the undervoltage lockout threshold, the start-up sequence
begins and the output ramps up at the externally set rate toward the set value of 1.8 V. The input voltage
for this plot is 5 V with a 1 Ω load.
Figure 9. TPS5432EVM-116 Start-Up Relative to V
IN
8
TPS5432EVM-116 3-A, SWIFT™ Regulator Evaluation Module SLVU674–March 2012
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated