Datasheet
SLVS426 − MAY 2002
www.ti.com
2
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam during
storage or handling to prevent electrostatic damage to the MOS gates.
ORDERING INFORMATION
T
A
PACKAGED DEVICES
PLASTIC TQFP (PT)
(1)
−40°C to 85°C TPS5130PT
(1)
The PT package is also available taped and reeled. Add an R suffix to the device type (i.e.,
TPS5130PTR).
PACKAGE DISSIPATION RATINGS
PACKAGE
(1)
T
A
≤ 25°C
POWER RATING
DERATING FACTOR
ABOVE T
A
= 25°C
T
A
= 85°C
POWER RATING
48 pin PT 3210 mW 25.7 mW/°C 1670 mW
(1)
These devices are mounted on a JEDEC high-k board (2 oz. traces on surface, 2-layer 1 oz. plane
inside). (Assumes the maximum junction temperature is 150°C)
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range unless otherwise noted
(1)
TPS5130
Supply voltage,
(2)
VIN −0.3 V to 30 V
(2),
LH1/2/3 −0.3 V to 35 V
(2),
VIN_SENSE12/3, LL1/2/3, STBY_LDO,
(2),
VIN_SENSE12/3, LL1/2/3, STBY_LDO,
STBY_VREF3.3/5, TRIP1/2/3
−0.3 V to 30 V
(2),
STBY_VREF3.3/5, TRIP1/2/3
−0.3 V to 30 V
Input voltage range
(2),
V
I
INV1/2/3, CT, SS_STBY1/2/3,
Input voltage range
(2),
V
I
INV1/2/3, CT, SS_STBY1/2/3,
INV_LDO, LDO_OUT, FLT,
INV_LDO, LDO_OUT, FLT,
PG_DELAY, VREF3.3/5,
−0.3 V to 7 V
PG_DELAY, VREF3.3/5,
LDO_IN, LDO_CUR, PWM_SEL,
−0.3 V to 7 V
LDO_IN, LDO_CUR, PWM_SEL,
REG5V_IN
(2)
OUT1/2/3_u −0.3 V to 35 V
Output voltage range, V
O
(2)
FB1/2/3, PGOUT, OUT1/2/3_d −0.3 V to 7 V
Output voltage range, V
O
(2)
LDO_GATE −0.3 V to 9 V
REF −0.3 V to 3 V
Operating ambient temperature range, T
A
−40°C to 85°C
Storage temperature, T
stg
−55°C to 150°C
(1)
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2)
All voltage values are with respect to the network ground terminal.