Datasheet

8 List of Materials
9 References
List of Materials www.ti.com
Table 4 lists the materials required for the TPS51120EVM.
Table 4. List of Materials
REFERENCE
QYT VALUE DESCRIPTION SIZE PART NUMBER MFR
DESIGNATOR
C1, C3, C4, C6,
9 C7, C8, C9, C10, 10 µ F Capacitor, Ceramic, 10 V, X7R, ± 10% 0805 Std Std
C16
2 C11, C14 1 µ F Capacitor, Ceramic, 10 V, X5R, ± 10% 0603 Std Std
1 C15 10 pF Capacitor, Ceramic, 50 V, COG, ± 5% 0603 Std Std
1 C2 1 nF Capacitor, Ceramic, 50V, X7R, ± 10% 0603 Std Std
3 C5, C12, C13 0.1 µ F Capacitor, Ceramic, 16V, X7R, ± 10% 0603 Std Std
J1, J2, J3, J4, J5,
6 Terminal Block, 2-pin, 6 A, 3.5 mm 0.27" × 0.25" ED555/2DS OST
J6
Header, Male 3-pin, 100 mil spacing, (36-pin
1 J7 0.100" x 3" PTC36SAAN Sullins
strip)
Header, Male 2-pin, 100 mil spacing, (36-pin
1 J8 0.100" x 2" PTC36SAAN Sullins
strip)
2 Q1, Q2 MOSFET, N-channel, 30 V, 50 A, 2.2 m Ω TDSON-8 BSC022N03S Infineon
2 R1, R5 10 k Ω Resistor, Chip, 1/10W, 5% 0603 Std Std
2 R10, R16 100 Ω Resistor, Chip, 1/8W, 1% 0805 Std Std
1 R14 1 k Ω Resistor, Chip, 1/10W, 5% 0603 Std Std
1 R15 7.5 k Ω Resistor, Chip, 1/10W, 5% 0603 Std Std
1 R18 0 Resistor, Chip, 1W, 5% 2512 CRCW25120000Z0EG Vishay
4 R2, R3, R9, R17 100 k Ω Resistor, Chip, 1/10W, 5% 0603 Std Std
1 R4 10 Ω Resistor, Chip, 1/10W, 5% 0603 Std Std
4 R7, R8, R12, R13 1.5 Ω Resistor, Chip, 1W, 5% 2512 CRCW25121R50JNEG Vishay
1 S1 Switch on-on Mini Toggle 0.28 x 0.18" G12AP-RO NKK
TP1, TP3, TP4,
6 Test point, red, thru-hole 0.125" x 0.125" 5010 Keystone
TP7, TP13, TP18
TP2, TP5, TP6,
8 TP12, TP14, Test point, black, thru-hole 0.125" x 0.125" 5011 Keystone
TP16, TP17, TP19
TP8, TP9, TP10,
5 Test point, white, thru-hole 0.125" x 0.125" 5012 Keystone
TP11, TP15
1 U1 IC, Sink/Source DDR Termination Regulator DRC TPS51200DRC TI
1 U2 IC, QUAD, 2-input positive NAND gates SO-14 SN74AHCT00D TI
IC, Dual 4-A High Speed low-side power
1 U3 SO-8 UCC27325D TI
MOSFET drivers
1 U4 IC, Precision Timer TSSOP-8 NE555PW TI
0 R6,R12 Not installed
3.4" × 2.2" x
1 Printed circuit board HPA322 Any
0.0625"
4 Bumpon Rubber bumper bumpon, transparent 0.44" × 0.2" SJ5303 3M
2 Jumper lack 0.100'' 2-382811-1 Tyco/AMP
Integrated LDO With Switch-Over Circuit for Notebook Computers data sheet (SLUS808) .
Using the TPS51103EVM, Integrated 3.3V/5V Power LDO with Clock Output data sheet (SLUU303) .
18 Using theTPS51200 EVM Sink/Source DDR Termination Regulator SLUU323 – JUNE 2008
Submit Documentation Feedback