Datasheet

( ) ( )
( )
f
IN OUT OUT
TRIP RIPPLE TRIP
OCP
IN
DS on DS on
V V V
V I V
1
I
R 2 R 2 L V
- ´
= + = + ´
´ ´
( )
( ) ( )
( )
TRIP TRIP
TRIP
R k I A
V mV 24 mV
9
W ´ m
= -
TPS51125
www.ti.com SLUS786G –OCTOBER 2007–REVISED JUNE 2012
Current Protection
TPS51125 has cycle-by-cycle over current limiting control. The inductor current is monitored during the ‘OFF’
state and the controller keeps the ‘OFF’ state during the inductor current is larger than the over current trip level.
In order to provide both good accuracy and cost effective solution, TPS51125 supports temperature
compensated MOSFET R
DS(on)
sensing. ENTRIPx pin should be connected to GND through the trip voltage
setting resistor, R
TRIP
. ENTRIPx terminal sources I
TRIP
current, which is 10 μA typically at room temperature, and
the trip level is set to the OCL trip voltage V
TRIP
as below. Note that the V
TRIP
is limited up to about 205 mV
internally.
(3)
External leakage current to ENTRIPx pin should be minimized to obtain accurate OCL trip voltage.
The inductor current is monitored by the voltage between GND pin and LLx pin so that LLx pin should be
connected to the drain terminal of the bottom MOSFET properly. Itrip has 4500 ppm/°C temperature slope to
compensate the temperature dependency of the R
DS(on)
. GND is used as the positive current sensing node so
that GND should be connected to the proper current sensing device, i.e. the source terminal of the bottom
MOSFET.
As the comparison is done during the ‘OFF’ state, V
TRIP
sets valley level of the inductor current. Thus, the load
current at over current threshold, I
OCP
, can be calculated in Equation 4.
(4)
In an overcurrent condition, the current to the load exceeds the current to the output capacitor thus the output
voltage tends to fall down. Eventually, it ends up with crossing the under voltage protection threshold and
shutdown both channels.
Over/Under Voltage Protection
TPS51125 monitors a resistor divided feedback voltage to detect over and under voltage. When the feedback
voltage becomes higher than 115% of the target voltage, the OVP comparator output goes high and the circuit
latches as the top MOSFET driver OFF and the bottom MOSFET driver ON.
Also, TPS51125 monitors VOx voltage directly and if it becomes greater than 5.75 V the TPS51125 turns off the
top MOSFET driver.
When the feedback voltage becomes lower than 60% of the target voltage, the UVP comparator output goes
high and an internal UVP delay counter begins counting. After 32 μs, TPS51125 latches OFF both top and
bottom MOSFETs drivers, and shut off both drivers of another channel. This function is enabled after 2 ms
following ENTRIPx has become high.
Copyright © 2007–2012, Texas Instruments Incorporated Submit Documentation Feedback 25
Product Folder Link(s): TPS51125